3D Printer Filament Dryer, Sovol SH01 Filament Dehydrator Spool Holder, Dry Box for Keeping Filament Dry During 3D Printing, Compatible with 1.75mm, 2.85mm PLA PETG TPU ABS Material Filament Dryer SH01

Remove Excess Moisture - 3D printer filaments are hygroscopic, moisture would cause printing failure. Sovol SH01, a great addition to 3d printer, can remove excess moisture, keep your filament dry and bring you better prints. The surface of prints will be smoother, the layer adhesion increased. No more brittle PLA, PETG, ABS filament
Real-time Monitoring of Temp and Humidity inside - Displays the humidity and temperature in the dry box in real time. Setting temperature 40 °, 45 °, 50 ° C and setting time from 6 hours to 12 hours. If you use SH01 in a room with room temperature under 16℃, the temperature in the dryer box would not come up to 50℃. But do not worry, this would not decrease drying effect
Excellent Power-off Drying Mode - Silicone & PTFE seal makes it possible to store filaments for a long time without power and protects your filaments from moisture and dirt. You can put 4 bags of desiccants (not included in the package) inside the dryer box to improve drying efficience & quality
Large Capacity - Sovol dryer box can store 2 filament rolls with a width of less than 70 mm or 1 filament roll with a width of less than 150 mm. Please open the PTFE seals on the top of the box during heating for Moisture evaporation
Heating More Evenly - The unique design of the built-in fan in the box is based on the principle of modynamics of air, makes the filament heated more evenly. SH01 makes drying more efficient. Any questions about the product please feel free to let us know. Our technical support team will provide service as soon as we can
You Must Know - Place the filament into the filament outlet. Please note that the direction is placed counterclockwise so that the pulley at the bottom can feed better.If the screen displays two errors, E0 and E1, please open the drying box and check all the cable sockets on the motherboard to see if they are damaged or loose. If there is any problem, please feel free to let us know. We will send replacement for you

3D Printer Filament Dryer, Sovol SH01 Filament Dehydrator Spool Holder, Dry Box for Keeping Filament Dry During 3D Printing, Compatible with 1.75mm, 2.85mm PLA PETG TPU ABS Material Filament Dryer SH01

Sovol-Eu

Cookies Policy