BOSS Audio Systems BASS8K 8 Inch Powered Under Seat Car Subwoofer Amplifer Wiring Kit - 800 Watts Max, Single 2.6 Ohm, Voice Coil, Built in Amp 8 inch Speaker XS With Wiring Kit

KIT - 17’ red power cable w ring terminal & rubber boot pre-installed, 3’ black ground cable, 16’ blue remote cable, 40A fuse, 16’ RCA, 1 large black rubber terminal boot, 1 ring terminal, 7 wire ties, plastic groumet, 1 tap screw
Space Saver - If you are tight on space, this is a great solution for you. The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. With a slim design, there are a few installation options
Pulse Width Modulated - PWM simplifies power supplies. It controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. Efficiency. Increased reliability
Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BASS8K to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs